Table of Contents
Advertisement
Available languages
Available languages
4.3
REMOTE CONTROL BUTTON.
4.4
REMOTE CONTROL MENU' .
Nr
Button
1
On / Off
The On / Off button allows the indoor unit to be switched on and off.
The fan speed is set in the sequence shown below, by pressing the "Fan speed setting" button: "AUTO (automatic) - LOW
2
Fan speed setting
(low) - MED (medium) - HIGH (high)".
3
Increases the set temperature.
Adjust
Air direction
4
Activate the "Wind horiz swing" function or the air deflector. After pressing, the deflector turns 6 °.
setting
Shows the time (when the unit is reset or turned on for the first time, 12.00 appears). Press the "Clock" button for 5
5
Time setting
seconds. The time icon flashes for 3 seconds. Press again and the minute icon will flash. The
set the values. After setting the value, confirm it by pressing the "OK" confirmation key.
This button is used to activate and configure the programmed power-on function. At each pulse the switch-on time
6
Timer On
increases by half an hour. When the selection exceeds 10 hours, the time will be increased from hour to hour. Set the
time to "0.0" and the automatic switch-on will be canceled.
This button is used to activate and configure the programmed shutdown function. At each pulse the switch-off time
7
Timer Off
increases by half an hour. When the selection exceeds 10 hours, the time will be increased from hour to hour. Set the
time to "0.0" and the automatic shut-off will be canceled.
Economic
Activate the economic operating mode. It is recommended to use this mode during sleep hours. With this parameter,
8
operation
the fan will operate in "AUTO" mode
(Inside the remote control). Press this button with a 1 mm needle to change from "Cool Only" mode to "Cool and Hot"
9
Cool / Heat
mode. During adjustment, a rear light is switched on. The factory default configuration is in "Cold and Hot" mode.
10
Reset
(Inside the remote control). Press this button with a 1 mm needle to clear the current setting and reset the remote control.
(Inside the remote control). Press this button with a 1 mm needle to lock or unlock the remote control, thus deactivating
11
Lock
all buttons of the same, except the "LOCK" button.
Key:
1 - On / Off
2 - Fan speed setting
3 - Adjust
4 - Air direction setting
5 - Time setting
6 - Timer On
7 - Timer Off
8 - Economic operation
9 - Cool/ Heat
10 - Reset
11 - Lock
12 - Confirm button
13 - Wind horiz swing
14 - Wind vert. swing
15 - Adjust
16 - Mode setting
Function
37
4-2
and
keys are used to
Advertisement
Table of Contents
