Table of Contents
Advertisement
Available languages
Available languages
2.4 COMPONENTS.
4
7
8
9
6
Key:
1 - Air inlet
2 - Front panel
3 - Display
4 - Air outlet
5 - Horizontal fins
Open the front panel to see the temporary but-
ton for the display panel (14 Fig. 2-1).
This function is used to temporarily start the
unit if the remote control is not positioned cor-
rectly or if the batteries are flat.
Two modes can be selected with the "TEMPO-
RARY" button: "AUTO" and "FORCED COOL".
When the button is pressed, the fan coil will
run in the following order: AUTO, FORCED
COOL, OFF and then AUTO again.
2
1
3
5
6 - Remote control
7 - Water inlet pipe
8 - Water return pipe
9 - Drain pipe
10 - Operation LED
• AUTO
The OPERATION LED is on and the fan coil
runs in AUTO mode. The remote control
works based according to the signal received.
• FORCED COOL
The OPERATION LED flashes, the fan coil
switches to AUTO mode after forced cooling
with a HIGH fan speed for 30 minutes. The
remote control is not active.
12
3
11
11 - Front panel
12 - Infrared signals receiver
13 - Temperature display
14 - "Temporary" button
• OFF
The OPERATION LED turns off. The fan coil
is OFF, while the remote control is reactivated.
Note: for the remote control instructions, see
chapter 4.1 "Remote controller".
30
13
10
14
2-1
Advertisement
Table of Contents
