Oil Injection Rate; Break-In Oiling - BRP Evinrude E-Tec Series Service Manual

Oil Injection Rate

If the owner desires, the Engine Management
Module (EMM) on Evinrude E-TEC models can be
programmed for the exclusive use of XD100,
which will significantly reduce oil consumption.
CAUTION
Running an Evinrude E-TEC outboard on
other grades of oil while set to the XD100
oil ratio will result in increased engine
wear and shortened outboard life.
The TC-W3 OIL control setting allows the out-
board to be run on TC-W3 outboard lubricant.
Changing to the optional XD100 OIL CONTROL
setting requires the use of Evinrude XD100 out-
board lubricant. Running the outboard in XD100
OIL mode can reduce oil consumption by approxi-
mately one third. Refer to Oil Control on p. 109.
Powerhead oil programming labels are provided
to identify EMM oil programming. Install the cor-
rect label to alert user to specific oil requirements.
Make sure the engine label and
IMPORTANT:
boat decal match EMM programming.
1
1. Evinrude/Johnson XD30 outboard lubricant (TC-W3)
YELLOW label
2. Evinrude/Johnson XD100 outboard lubricant (Premium)
BLUE label (Installed)
XD100 Outboard Oil Decal
Evinrude/Johnson XD100 oil decals are available
to label boats equipped with Evinrude E-TEC out-
boards that have been programmed for the
XD100 oil injection ratio.
INSTALLATION AND PREDELIVERY
Use the XD100 Outboard Oil Decal, P/N 352369,
to accurately inform the boat operator of the
XD100 outboard oil requirement.
XD100 Outboard Oil Decal
Install decal(s) in one or more of the highly visible
recommended locations to alert the outboard
operator(s).
Recommended Locations:
Dashboard/deck of boat, adjacent to key switch
•
Deck of boat, adjacent to the remote oil fill
•
Deck of boat, adjacent to oil tank assembly
•
Oil tank cover
•
Cover of oil tank compartment
•
Attach to oil tank or oil fill cap
•
2

Break-In Oiling

IMPORTANT:
on Evinrude E-TEC models.
The Engine Management Module (EMM) will auto-
matically supply extra oil to the engine during the
first two hours of operation above 2000 RPM.
Follow these steps for initial outboard set-up:
Use the Evinrude Diagnostics Software pro-
•
004964
gram to confirm that the break-in program has
been initiated. Refer to Oil Control on p. 109.
The oil tank should be filled and the oil level
•
accurately marked for reference.
Fill the fuel tank with the recommended fuel.
•
IMPORTANT:
tank level to confirm oil consumption. This may
require several hours of operation above idle
speed.
FUEL AND OIL PRIMING
DO NOT add oil in the fuel tank
The operator must monitor the oil
2
004522
67