BRP Evinrude E-TEC Series Service Manual page 92

ELECTRICAL AND IGNITION
STATOR TESTS
R S M
OPE TART ODELS
Use a Peak Reading Voltmeter, P/N 507972, to
check stator output voltage. Set meter to the
50 VAC scale.
WARNING
To prevent accidental starting of outboard,
disconnect crankshaft position sensor
(CPS).
Disconnect CPS. Remove spark plugs. Make sure
outboard is in NEUTRAL. Refer to SPARK
PLUGS on p. 36.
Disconnect stator (6-pin) connector from the
engine harness (6-pin) connector.
Connect Stator Test Adaptor tool, P/N 354719, to
stator connector.
90
Connect meter leads to terminals of adaptor tool.
Rotate the flywheel with the starter rope, using a
long, steady pull.
Stator output voltage should be approximately
30 VAC.
1. Stator Test Adaptor
IMPORTANT:
Index all spark plugs. Refer to
Spark Plug Indexing on p. 36.
1
006750