LOWER COVER SERVICE
Lower Cover Removal
Remove cable entry cover screws, cover and
cable entry grommets.
1. Cable entry cover screws
2. Cable entry cover
3. Cable entry grommets
Remove lower engine cover screws.
1
1. Lower cover screws
Lower Cover Installation
Installation of lower motor covers will be easier if
the following steps are performed in order:
•
Install air silencer on throttle body.
•
Install fuel hose on fuel connector fitting. Secure
with new Oetiker clamp. Place port cover on
outboard. If equipped, route battery and trim
cables through grommet opening.
1
•
Place starboard side cover into position on out-
board.
2
3
1
007308
2
1. Grommet opening
2. Battery cable
Start the screw below the exhaust relief grommet
first. Tighten just enough to hold the grommet in
place.
1
1
007309
1. Start this screw first
2. Exhaust relief grommet
ENGINE COVER SERVICE
LOWER COVER SERVICE
3
007310
2
007311
45