Water Pump Overboard Indicator
A steady stream of water should flow from the
overboard indicator.
1. Water pump overboard indicator
Operating Temperature
An outboard run at idle speed should achieve a
temperature based on the engine's thermostatic
control. In general, the powerhead temperature
should reach at least 104°F (40°C) after five min-
utes of idling. Check that the powerhead reaches
idle temperature. Refer to SERVICE SPECIFICA-
TIONS on p. 10.
Idle Speed
Make sure the outboard idles within the specified
idle RPM range. If the outboard is run on a flush-
ing device, the idle speed and quality may not be
representative of actual in water use.
COOLING SYSTEM
Check the condition of cooling system compo-
nents regularly:
•
water intake screens
1
•
water pump
•
all internal water passages
•
thermostats
•
all external water hoses and fittings
•
vapor separator cooling passages and fittings
•
EMM cooling passages and fittings
•
overboard water pressure indicator.
Water Intake Screens
Inspect condition of water intake screens. Clean
007031
or replace as needed.
Confirm function of overboard water pressure indi-
cator.
1
1. Water intake screen
2. Overboard indicator
ROUTINE SERVICE
COOLING SYSTEM
2
007271
007016s
29
2