BRP Evinrude E-TEC Series Service Manual page 289

pulley. Secure retainer with left-hand threaded
nut.
1. Retainer tapered end
Install handle on pulley pin. Pull lightly on spring
and turn pulley counterclockwise with handle until
hook end of spring engages the pulley.
1. Pull on spring
Turn pulley counterclockwise until spring is com-
pletely pulled into housing.
Allow pulley to slowly unwind until tension is
relieved.
Turn pulley counterclockwise 3.5 turns, until the
pulley rope channel aligns with the rope guide.
2
1
007719 1. Rope channel
2. Rope guide
Secure pulley by placing stop tool through the
holes in the pulley and housing.
1
1. Stop tool
007720
If replacing rope, pull new rope through handle.
Tie a knot as shown.
Handle Knot Detail
MANUAL STARTER
RECOIL STARTER ASSEMBLY
1
007734
1
007721
0.375 in.
9.5 mm
007722
14
287