Recoil Starter Assembly - BRP Evinrude E-TEC Series Service Manual

MANUAL STARTER

RECOIL STARTER ASSEMBLY

RECOIL STARTER
ASSEMBLY
WARNING
Wear safety glasses while disassembling
and assembling manual starters because
of rewind spring tension.
If removed, install the rope guide to the starter
housing. Tighten screws securely.
1
1. Rope guide
Apply Moly Lube to both sides of pulley spring
shield. Place shield on pulley as shown.
286
Clamp base of Starter Spring Winder and Installer,
P/N 342682, in a vise. Place spring around base
as shown.
Place starter housing over base.
Route the hook end of spring through the starter
housing opening as shown. To keep spring in
position, hold up on portion of spring that is out-
side of the housing.
007715
1
1. Spring hook end
2. Opening
Place pulley over base and place retainer over
pulley. Be sure tapered end of retainer is toward
007718
007716
2
007717