BRP Evinrude E-TEC Series Service Manual page 279

Position the motor on the manifold and install four
new screws and lock washers. Tighten the screws
35 to 50 in. lbs. (4 to 5.6 N·m).
Oil O-rings and install them on the manual release
valve. Oil and install the manual release valve.
Tighten the valve to a torque of 45 to 55 in. lbs. (5
to 6 N·m).
Install retaining ring in groove.
1
1. Retaining ring
Fill the oil reservoir up to the fill plug with
Evinrude/Johnson
Install the fill plug.
002531
Run the motor, then recheck oil level. Cycle the
unit several times and check the oil level when the
cylinder is fully extended. Oil should be level with
bottom of fill port. Install and tighten the fill plug to
a torque of 45 to 55 in. lbs. (5 to 6 N·m).
002529
002534
TRIM AND TILT
TRIM AND TILT SERVICE
Biodegradable TNT
007646
007647
Fluid.
13
277