TRIM AND TILT
TRIM AND TILT REPLACEMENT
Remove the clip from the cylinder pin.
Thread Adapter, P/N 340624, onto Slide Hammer,
P/N 391008. Screw the adapter into the cylinder
pin and remove the pin.
3
1. Adapter
2. Slide hammer
3. Cylinder pin
Remove one of the locknuts from the angle adjust-
ment rod. Remove the rod from the stern brack-
ets.
274
Remove the unit from the stern brackets far
enough to remove the ground lead from the pump
motor mounting screw.
1
15493
1. Ground lead
Installation
Lubricate the cylinder and thrust rod bushings with
1
Triple-Guard grease. Install the bushings.
2
1
007638
1
1. Bushings
Install the ground lead.
Place trim/tilt unit into position.
007639
007640
007648