Tiller Height Adjustment
The angle of the tiller handle can be raised or low-
ered by adjusting a thumbscrew under the handle.
1
1. Height adjustment screw
Tiller Handle Ratchet
Tiller models feature a ratchet which holds the
tiller arm at approximately 30° or 90° positions. To
release the tiller arm, press up on the release
lever.
1. Release lever
Tiller Handle Friction
The tiller handle screw may be tightened to adjust
the amount of friction when tilting the tiller handle.
1
007453
1. Screw
Neutral Switch Adjustment
Adjust neutral switch as follows:
Make sure neutral switch is centered on shift lever
detent.
•
Loosen two neutral switch bracket screws.
•
Center the neutral switch on lobe of the shift
lever detent.
•
Hold neutral switch bracket in position and
tighten screws to a torque of 35 to 60 in. lbs.
(4 to 6.8 N·m).
1
1
3
007483
1. Neutral switch
2. Lobe of shift lever detent
3. Neutral switch bracket screws
Check Neutral Switch Operation
Use Evinrude Diagnostics software "Monitor"
screen to confirm neutral switch operation.
ROUTINE SERVICE
ADJUSTMENTS
007484
3
008462
25
2