BRP Evinrude E-TEC Series Service Manual page 268

GEARCASE
GEARCASE ASSEMBLY
Install one screw in the bearing housing. Remove
the guide pin and install the second screw.
Tighten screws to a torque of 124 to 142 in. lbs.
(14 to 16 N·m).
Apply Adhesive 847 to the bottom of a new
exhaust seal assembly and install it into the slot in
the gearcase.
1. Seal assembly
To complete gearcase assembly, refer to:
•
WATER PUMP SERVICE on p. 250
•
GEARCASE LEAK TEST on p. 247
•
GEARCASE REMOVAL AND INSTALLATION
on p. 248
•
Gearcase Lubricant on p. 34
•
Propeller Hardware Installation on p. 246
•
Trim Tab Adjustment on p. 27.
During break-in period of a reassembled gear-
case, change the gearcase lubricant between 10
to 20 hours of operation.
266
1
007667