BRP Evinrude E-TEC Series Service Manual page 267

NOTICE
The retaining ring is under extreme
pressure during installation. Make sure that
the ring is seated in groove.
1. Retaining ring
Thread one Guide Pin, P/N 383175, into the
retainer plate.
1. Guide pin
Use Needle Bearing grease to temporarily hold
the reverse gear thrust washer on the back of the
propeller shaft bearing housing.
1
1. Reverse gear thrust washer
Lightly apply Gasket Sealing Compound to the aft
support flange of the bearing housing. Align the
propeller shaft bearing housing on the guide pin
with the word "UP" toward the top.
1
1
COA3239 1. Guide pin
2. "UP"
Using a brass punch and a mallet, seat the bear-
ing housing in the gearcase.
1
COA3240
Place new O-rings on the bearing housing retain-
ing screws. Apply Gasket Sealing Compound to
the O-rings and threads of the screws.
COA3309
1. Screws
GEARCASE
GEARCASE ASSEMBLY
COA3241
38639
COA3243
265
2
12
1