GEARCASE
BEARING AND SEAL INSTALLATION
Propeller Shaft Bearing Housing
Seals and O-ring
Remove and discard the propeller shaft bearing
housing O-ring.
1
1. O-ring
Use Puller Bridge, P/N 432127, and Small Puller
Jaws, P/N 432131, to remove seals. Discard
seals.
1. Small puller jaws
Use Puller Bridge, P/N 432127, and Small Puller
Jaws, P/N 432131, to remove both propellers
shaft bearings from the bearing housing. Discard
both bearings.
1. Small puller
258
BEARING AND SEAL
INSTALLATION
IMPORTANT:
cate all bearings, shafts, and gears with gearcase
lubricant.
Press the bearings into the housings until the
tools are seated on the housing.
Propeller Shaft Bearing
Housing Bearings
Use Bearing Installer, P/N 335820, to install a new
bearing in the rear end of bearing housing. Posi-
007680
tion installer against the lettered side of bearing.
Press the bearing into the housing until the tool is
seated on the housing.
1
32555
Use Bearing Installer, P/N 321428, to install a new
bearing in the forward end of the bearing housing.
Position installer against the lettered side of bear-
ing.
1
21795
Make no dry assemblies. Lubri-
21793
21794