BRP Evinrude E-TEC Series Service Manual page 253

Lightly coat the exterior of the impeller cup with
Gasket Sealing Compound. Align tabs of impeller
cup with location holes of impeller housing and
install the impeller cup into the impeller housing.
1
1. Tabs, impeller cup
2. Location holes
Lightly coat the inside of the impeller cup with oil.
With a counterclockwise rotation, install the impel-
ler into the impeller cup.
IMPORTANT:
The sharp edge of key slot in the
impeller is the leading edge during rotation.
1
1. Impeller
2. Sharp edge
Apply Adhesive 847 to the outer seal groove of
the impeller housing. Install a new seal into the
groove.
1
2
1. Seal
007659
Lightly oil pinion splines of the driveshaft. Slide the
driveshaft through the impeller housing and impel-
ler until drive key flat of the driveshaft is below the
impeller. Align drive key flat with groove of the
impeller. Install the impeller drive key.
1
2
1. Drive key
007660
GEARCASE
WATER PUMP SERVICE
007661
007662
12
251