Installation - BRP Evinrude E-TEC Series Service Manual

Install shift handle. Install shift handle screw.
Tighten screw securely.
1
1. Screw
2. Shift handle

Installation

Place tiller bracket on steering arm.
Install screw and washer in front mounting hole.
1
2
1. Screw
2. Washer
The tiller handle angle can be set to center or
angled to port or starboard 20° .
Install rear washer and screw in appropriate loca-
tion.
Tighten both screws to a torque of 18 to 20 ft. lbs.
2
(25 to 27 N·m).
007529
1. Screw
2. Washer
Install locknuts on screws.
Hold screws with a wrench and tighten locknuts to
a torque of 18 to 20 ft. lbs. (25 to 27 N·m).
007460
3. Locknuts
Route tiller control wiring as shown.
007214
MIDSECTION
TILLER HANDLE SERVICE
1
2
007461
1
007462
11
239