BRP Evinrude E-TEC Series Service Manual page 240

MIDSECTION
TILLER HANDLE SERVICE
If trim switch was removed, install tie straps on
harness. connectors.
1
1. Tie straps
Install connectors on trim switch wires. Refer to
CONNECTOR SERVICING on p. 111. Connect
start switch connectors.
1. Trim switch connectors
1. Start switch connectors
238
Install start switch. Tighten start switch nut
securely. Install stop switch housing, spring, but-
ton and stop switch. Secure with two screws.
Tighten screws securely.
1
1
007681
1. Screws
2. Start switch nut
Route shift and throttle cables, and wiring harness
as shown.
1
007533
1. Screws
1
2. Start switch nut
Install bottom cover of tiller handle with eight
screws. Tighten screws securely.
007531
007532
1. Cover screws
2
007530
007563
1
007528