BRP Evinrude E-TEC Series Service Manual page 238

MIDSECTION
TILLER HANDLE SERVICE
Apply Lubriplate to the ends of pin, guides, rollers,
helix grooves and inner handle guide slot. Place
the guides over the roller pin and into the slots of
the inner handle. Place the rollers on the ends of
the roller pin.
1. Roller
Assemble the helix halves on the handle and slide
the grip over the helix.
Carefully pull trim switch wires through inner tiller
handle as twist grip assembly is installed.
1
1. Trim switch wiring
236
Be sure the twist-grip's speed indicator line is
positioned with the speed range symbol on the
handle. Snap the grip into place.
1
1. Indicator line
Place trim switch wiring under throttle cable as
007557
shown.
1. Trim switch wiring
Place Touch Troll wiring under throttle cable as
007558
shown. Install touch troll switch bracket with three
screw. Tighten screws securely.
2
1. Wiring
2. Throttle cable
007559
3. Screws
1
007481
1
007560
3
1
007561