BRP Evinrude E-TEC Series Service Manual page 237

Push wire guide into place until locking tab is in
place as shown.
1
1. Locking tab
Wire guide should slide easily into place. If any
binding is felt, inspect trim switch wiring for twist-
ing. If wire guide is forced into place, it WILL dam-
age trim switch wiring.
1
1. Inner tiller handle
2. Wire guide
3. Trim switch wires
Make sure trim switch wiring is NOT twisted
before proceeding.
1
007555 1. Inner tiller handle
2. Wire guide
007556
3. Trim switch wires
Install the throttle cable.
2
3
Install the throttle pin in the cable.
006684
MIDSECTION
TILLER HANDLE SERVICE
1
2
3
006675
007544
11
007543
235