Inspection; Assembly - BRP Evinrude E-TEC Series Service Manual

MIDSECTION
TILLER HANDLE SERVICE
If replacing tilt detent pawl, tilt release lever, tilt
detent pin or spring, remove cotter pin and roll
pins as needed.
1. Cotter pin
1. Roll pins
Remove four screws and bushing from bracket.
Remove bracket from handle.
2
1
1. Screws
2. Bushing
232

Inspection

Inspect the throttle cable for kinks and wear.
Replace if necessary.
Inspect the shift cable for kinks and wear. Replace
if necessary.
Inspect the steering handle components for wear,
cracks, or damage. Replace parts if necessary.
Refer to Emergency Stop Switch Test on p. 99
to test stop switch.

Assembly

1
Install bracket on handle. Install four screws.
007550
Tighten screws securely and install bushing in
bracket.
CAUTION
When reinstalling screws in composite
materials turn screws COUNTER-CLOCK-
WISE until threads of screw engage
threads of screw boss.
Failure to follow this procedure will dam-
age the screw boss threads. Once threads
1
are engaged, tighten screws securely.
007551
2
1
1. Screws
2. Bushing
007552
007552