Tiller Handle Service; Removal - BRP Evinrude E-TEC Series Service Manual

TILLER HANDLE
SERVICE

Removal

WARNING
To avoid accidental starting of engine
while servicing, twist and remove all spark
plug leads.
Remove lower engine covers. Refer to Lower
Cover Removal on p. 45.
Disconnect tiller electrical connector and trim con-
nector, if equipped.
1. Tiller electrical connector
Use Ball Socket Remover Tool, P/N 342226, to
remove throttle cable connector from throttle
lever. Remove screw and washer from throttle
cable retainer.
1. Throttle cable connector
2. Throttle cable retainer
Remove clip and washer from shift lever pin and
remove shift cable connector from shift lever pin.
Remove cable anchor screw and washer from
shift cable retainer.
1. Shift cable connector
2. Shift cable retainer
1
Remove locknuts from screws on bottom of
steering arm.
007474
1. Locknuts
Remove front steering handle screw and washer.
1
2
1
007471
1. Front steering arm screw and washer
MIDSECTION

TILLER HANDLE SERVICE

1
2
007467
1
007462
11
007460
227