BRP Evinrude E-TEC Series Service Manual page 226

MIDSECTION
STERN BRACKET – MANUAL TILT MODELS
Install pin through each lock assembly and stern
bracket. Install washers and nuts, and tighten to a
torque of 18 to 20 ft. lbs. (24.5 to 27 N·m).
1
1. Pin
2. Nut and washer
Apply Ultra Lock to the threads of the tie bar
screws. Install the screws and tighten to a torque
of 144 to 168 in. lbs. (16 to 19 N·m). Install the tilt
pin.
1
1. Tie bar screws
Tighten the tilt tube nuts to a torque of 40 to 45 ft.
lbs. (54 to 61 N·m), then back off 1/8 to 1/4 turn.
224
Install friction screw and spring in swivel bracket.
Apply a light coat of Triple-Guard grease to the
outside of the upper bushing.
Install upper bushing. Make sure bushing slots are
aligned with slots in swivel bracket.
2
1
007592
007591
1. Slots
Make sure friction plate is aligned toward friction
screw.
007590
1. Friction plate
2. Friction screw
007589
1
007619
007620
2
1
007618