Systemcheck Harness Connections - BRP Evinrude E-TEC Series Service Manual

ROUTINE SERVICE
OUTBOARD RIGGING CONNECTIONS
SystemCheck Harness
Connections
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
1. Seal
Route electrical harness along the edge of the
lower engine cover.
1
1. Key switch connector
2. Tachometer connector
Secure connectors to lower motor cover with two
tie straps as shown.
2
1. Wire routing
2. Secure with two tie straps
20
Route trim and tilt connector under air silencer.
Use tie strap to secure connector as shown.
1. Trim and tilt connector
1
Install battery cables and secure with tie strap.
42079A
1
2
1. Tie strap
2. Battery cable ground
Route battery cable through grommet of port
lower motor cover.
007263
1
1. Battery cable grommet
NOTICE
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
007125
linkages.
1
007264
2
007240
1
008009