Stern Bracket - Manual Tilt Models; Clamp Screw Service; Stern Bracket Disassembly (Manual Tilt) - BRP Evinrude E-TEC Series Service Manual

MIDSECTION
STERN BRACKET – MANUAL TILT MODELS
STERN BRACKET –
Manual Tilt Models

Clamp Screw Service

Inspect clamp screw assemblies. Replace swivel
plate and shoulder screw if bent or loose.
Disassemble swivel plate and shoulder screw.
Inspect and clean clamp screw and shoulder bolt
threads.
Install clamp screw and handle assembly in tran-
som bracket.
1
1. Clamp screw and handle assembly
Install swivel plate, onto shoulder screw.
1. Swivel plate
2. Shoulder screw
216
Apply Locquic Primer to the threads of the screw
and allow it to dry four to five minutes. Then apply
Ultra Lock to threads.
Install shoulder screw and swivel plate onto clamp
screw and handle assembly.
Tighten screw to a torque of 60 to 84 in. lbs. (7.5
to 9 N·m).
Check for free movement of swivel plate on shoul-
der bolt.
Stern Bracket Disassembly
(Manual Tilt)
007579
If outboard is equipped with a tiller arm, remove
the tiller arm. Refer to TILLER HANDLE SER-
VICE on p. 227.
2
Remove exhaust housing. Refer to EXHAUST
HOUSING SERVICE on p. 203.
1
Remove lower mount bracket retaining screws.
007580
1. Screws
007581
1
007582