Trim Sending Unit Installation - BRP Evinrude E-TEC Series Service Manual

Trim Sending Unit Installation

Route trim sending unit harness through port stern
bracket grommet. Secure harness in wire clamp
as shown.
2
1. Grommet
2. Wire clamp
Place rear screw through hole. Place two washers
on rear screw. Position sending unit and install
rear screw.
2
1. Washers
2. Rear screw
Place ground wire over front screw and install
front screw. Tighten screws to a torque of 10 to 16
in. lbs. (1 to 2 N·m).
STERN BRACKET – POWER TILT MODELS
CAUTION
When reinstalling screws in composite
materials turn screws COUNTER-CLOCK-
WISE until threads of screw engage
threads of screw boss.
Failure to follow this procedure will dam-
age the screw boss threads. Once threads
are engaged, tighten screws securely.
1
1
007706
1. Front screw
Install trim sender electrical connector on harness.
Refer to CONNECTOR SERVICING on p. 111.
Install tie straps on cable clamp and harness.
1
1
007707
1. Cable clamp
2. Tie straps
IMPORTANT:
the wiring harness will not be damaged between
stern and swivel brackets.
MIDSECTION
Operate trim unit and make sure
007704
1
11
007705
215