MIDSECTION
STERN BRACKET – POWER TILT MODELS
Install lower mount retaining screws. Tighten
screws to a torque of 10 to 12 ft. lbs. (14.5 to 16.5
N·m).
1. Retaining screws
Tighten the tilt tube nuts to a torque of 40 to 45 ft.
lbs. (54 to 61 N·m), then back off 1/8 to 1/4 turn.
Install exhaust housing. Refer to EXHAUST
HOUSING SERVICE on p. 203.
Install tiller handle. Refer to TILLER HANDLE
SERVICE on p. 227.
Adjust tiller steering friction. Refer to Steering
Friction Adjustment on p. 24.
214
Trim Sending Unit Removal
Remove two screws. Remove sending unit and
washers from swivel bracket.
1
1
007682
1. Screws
Remove trim sender electrical connector from har-
ness. Refer to CONNECTOR SERVICING on
p. 111.
Remove tie straps from harness. Pull harness
from stern bracket to remove sending unit.
1
007703
1. Tie straps
007704
1
007705