BRP Evinrude E-TEC Series Service Manual page 214

MIDSECTION
STERN BRACKET – POWER TILT MODELS
Install the cylinder pin and secure with clip.
1. Clip
Tighten the locknuts to a torque of 60 to 84 in. lbs.
(7 to 9.5 N·m).
Install the trim sending unit. Refer to Trim Send-
ing Unit Installation on p. 215.
Apply a light coat of Triple-Guard grease to the
outside of the upper and lower bushings.
212
Install the upper and lower bushings in the swivel
bracket.
1
007637
Use Seal Installation tool, P/N 350958, to install
new upper and lower seals in the swivel bracket.
Install seals with lips of seals facing in.
007691
Install the steering friction plate, washers and
lever.
1. Steering friction plate
2. Steering friction washers
3. Steering friction lever
007689
007690
007701
007702
1
2
3
007686