BRP Evinrude E-TEC Series Service Manual page 21

Adjust the shift cable trunnion to align with the
center of the trunnion block.
1
1. Shift linkage
2. Shift cable
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
1. Cable retainer
With remote control lever in NEUTRAL, pull firmly
on throttle cable casing to remove slack.
With engine throttle lever against stop, place the
cable trunnion into the upper anchor pocket and
OUTBOARD RIGGING CONNECTIONS
adjust the trunnion nut so the casing fits onto the
throttle lever pin.
2
007215 1. Throttle cable trunnion
2. Trunnion block
2
1. Idle stop
IMPORTANT:
007121
WARD and pull back slowly to NEUTRAL. Make
sure the engine throttle lever is against the stop. If
not, remove slack by adjusting cable trunnion.
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
Install washers and retainer clips on shift lever
and throttle pins. Refer to Cable Retainer Clip
Installation on p. 17.
ROUTINE SERVICE
Move control handle to FOR-
2
2
1
007217
1
007216
19