BRP Evinrude E-TEC Series Service Manual page 207

Install washer. Align slot with pin as shown.
2
1
1. Slot
2. Pin
Apply Triple-Guard grease to threads of the upper
mount screw. Install screw through upper mount.
Tighten screw to a torque of 22 to 23 ft. lbs. (30 to
32 N·m).
IMPORTANT:
Make sure upper mount bumper
stop slot stays aligned with pin as screw is tight-
ened.
Lower mount: Apply Triple-Guard grease to
threads of the lower mount screws.
Install rubber bumper and washer.
Install screw through lower mount.
Tighten screw to a torque of 22 to 23 ft. lbs. (30 to
32 N·m).
1
007572
1. Rubber bumper
2. Washer
3. Screw
Tighten two mount to exhaust housing screws to a
torque of 10 to 12 ft. lbs. (14.5 to 16.5 N·m).
007573
Install lower motor covers. Refer to Lower Cover
Installation on p. 45.
MIDSECTION
EXHAUST HOUSING SERVICE
1
2
3
008427
007575
11
205