Exhaust Housing Service; Exhaust Housing Removal; Exhaust Housing Installation - BRP Evinrude E-TEC Series Service Manual

EXHAUST HOUSING
SERVICE
The exhaust housing contains no serviceable
internal parts. The exhaust relief muffler and
motor mounts can be serviced without removing
the exhaust housing.

Exhaust Housing Removal

Before removing the exhaust housing:
•
Remove the gearcase. Refer to GEARCASE
REMOVAL AND INSTALLATION on p. 248.
•
Remove the powerhead. Refer to POWER-
HEAD REMOVAL on p. 170.
Remove two upper mount and two lower mount
screws.
1
1. Upper mount screw
2. Lower mount screw
Remove bumpers and bumper stops from upper
mounts. Remove washers from lower mounts.
Remove the exhaust housing.
Exhaust Housing
Remove lower mount bracket rubber mount.
Check condition of the lower front mount. Replace
if deteriorated or damaged.
1
1. Rubber mount

Exhaust Housing Installation

Install lower mount bracket rubber mount.
Bring the exhaust housing into position with the
stern bracket.
2
007566
Exhaust Housing
Install bumpers, bumper stops and screws on
upper mounts. Install washers and screws on
lower mounts. Refer to Mount Service on p. 204.
Install gearcase. Refer to GEARCASE REMOVAL
AND INSTALLATION on p. 248.
Install powerhead.
INSTALLATION on p. 188.
007567
MIDSECTION

EXHAUST HOUSING SERVICE

Refer to POWERHEAD
007568
007567
11
203