Outboard Rigging Connections - BRP Evinrude E-TEC Series Service Manual

OUTBOARD RIGGING
CONNECTIONS
IMPORTANT:
For complete outboard rigging
and remote control installation information, refer to
the Predelivery and Installation Guide included
with the service manual set.
Common Practices – All Models
Control Cable Identification
IMPORTANT:
Control cable function must be
identified before rigging outboard.
Identify each control cable:
•
Put the control handle into NEUTRAL position.
The throttle cable casing guide will retract com-
pletely and the shift cable casing guide will go to
the midpoint of its travel.
1. Shift cable casing guide extended to midpoint
2. Throttle cable casing guide retracted
Extend the control cables and lubricate them with
Triple-Guard grease.

OUTBOARD RIGGING CONNECTIONS

Cable Retainer Clip Installation
When installing retainer clips on control arm link-
age pins, clips should be locked and must not be
bent or deformed.
For proper installation, review the following steps:
•
Place washer on pin.
•
Position retainer clip with straight section on the
bottom and angled section on the top.
•
Use long nose pliers to insert straight section of
clip into linkage pin hole.
1
1. Straight section
2. Angled section
•
Push the clip towards the hole while lifting on
the curved end with the pliers.
•
Be sure retainer clip fully engages the pin.
•
Lock the retainer by moving the angled section
behind the straight section.
2
DP0811
Locked Retainer Clip
1. Angled section behind straight section
30501
ROUTINE SERVICE
1
2
DP0818
DSC_4670
1
DP0817a
17
2