POWERHEAD
POWERHEAD ASSEMBLY
Test that the crankshaft spins freely without bind-
ing.
IMPORTANT:
After
assembled, allow at least two hours for Gel-Seal II
to cure before running outboard.
Apply Gasket Sealing Compound to both sides of
new inner and outer exhaust cover gaskets. Posi-
tion gaskets and covers on cylinder block.
2
1. Inner exhaust cover
2. Outer exhaust cover
Apply Nut Lock to cover screws. Tighten all
screws in sequence, to a torque of 84 to 106 in.
lbs. (9.5 to 12 N·m).
184
powerhead
has
been
007768
007769
Cylinder Head Installation
Apply soapy water to water dam and insert into
block.
1
1
1. Water dam tab
Place a new cylinder head gasket on alignment
pins.
1
1. Alignment pins
Install cylinder head with the thermostat toward
the top. Apply Triple-Guard grease to the threads
and install the cylinder head screws. DO NOT use
any sealant on threads
007770
007771
007772