Pistons And Connecting Rods - BRP Evinrude E-TEC Series Service Manual

enclosed face toward flywheel. Do not apply
sealer to outside edge of the seal.
1. Upper oil seal

Pistons and Connecting Rods

NOTICE
It is very important that the pistons
in this engine are installed in the correct loca-
tion and direction. Engine damage will occur if
installed incorrectly.
New pistons are stamped "UP." This marking
should be turned toward the top of the crankshaft.
1
1. Stamped marking
Apply outboard lubricant to the wrist pin bearings,
wrist pin and wrist pin bore. Install the bearings in
the small end of the connecting rod.
1
007761
1. Wrist pin bearings
Place the piston over the connecting rod and
bearings.
Install wrist pin through piston and connecting rod.
Use Wrist
P/N 354720, to install new wrist pin retaining rings
in each wrist pin hole. Place one retaining ring into
007800
tool base. Insert driver into base and through
retaining ring. Align tool on piston. Support piston
POWERHEAD
POWERHEAD ASSEMBLY
Pin Retainer Installation
1
007762
007763
10
Tool,
181