BRP Evinrude E-TEC Series Service Manual page 178

Hide thumbs Also See for Evinrude E-TEC Series:

Table of Contents

POWERHEAD DISASSEMBLY

Inspect housing and replace if necessary.

Remove the O-ring from crankshaft sleeve and

inspect it. Replace the O-ring if it is not in good

Inspect the crankshaft sleeve and replace if nec-

essary. To remove the sleeve, use Slide Hammer,

P/N 432128, and Puller Jaws, P/N 432130.

Remove the lower main bearing only if it needs to

be replaced. Use external retaining ring pliers to

remove the lower bearing retaining ring.

removed from the crankshaft, it must be dis-

carded. DO NOT reuse it.

Use a bearing separator to support the bearing,

and press off the crankshaft.

If the lower main bearing is

Chapters

Table of Contents