Oil Tank Assembly - BRP Evinrude E-TEC Series Service Manual

Install cylinder #2 oil distribution hose to the out-
board (furthest from powerhead) oil manifold port.
4
3
1
1. Hose retainer
2. Oil distribution manifold
3. Crankcase oil supply hose
4. Cylinder block oil supply hose
1
3
4
6 5
1. Hose retainer
2. Oil distribution manifold
3. #1 Cylinder
4. #2 Cylinder
5. Crankcase
6. Cylinder block
Refer to OIL SUPPLY DIAGRAMS on p. 143.
2
007334
2
3
4
5 6
007335
OIL COMPONENT SERVICING

Oil Tank Assembly

Removal
Disconnect the battery cables at the battery.
Disconnect the electrical connector to the oil injec-
tion pump.
Disconnect the electrical connector to the low oil
switch.
1
2
1. Oil pump connector
2. Low oil switch
IMPORTANT:
Note oil distribution hose rout-
ings before proceeding with disassembly.
Remove oil distribution hoses from the manifold.
Remove oil tank retaining screw.
1
1. Screw
OILING SYSTEM
007336
8
007288
155