Oil Component Servicing; Oil Distribution Hoses - BRP Evinrude E-TEC Series Service Manual

OILING SYSTEM

OIL COMPONENT SERVICING

OIL COMPONENT
SERVICING
WARNING
To prevent accidental starting while ser-
vicing, twist and remove spark plug leads.

Oil Distribution Hoses

Oil distribution hoses are different lengths. DO
NOT alter the length of any hoses.
Oil Distribution Hose Length:
•
Cylinder – 20 in. (508 mm)
•
Crankcase – 10.5 in. (267 mm)
Removal
Release the hose by depressing the outer ring of
the hose retaining mechanism.
2
1. Retainer mechanism
2. Hose support
Once hose is removed from the manifold, make
sure hose support is in the end of the hose.
1. Hose support
154
Installation
Cut Replacement Oil Hose, P/N 778708, to the
correct length. Insert hose support in manifold end
of hose.
IMPORTANT:
into manifold without a hose support.
Be sure the hose is fully inserted into manifold.
Insertion depth is 5/8 in. (16 mm). Visually inspect
for hose supports.
Oil distribution hoses have specific locations and
routing. DO NOT alter the location of any hoses.
The oil distribution manifold includes a built-in
hose retainer. Route oil distribution hoses up
through the retainer.
Install crankcase oil distribution hoses to the for-
ward oil manifold ports.
Install cylinder #1 oil hose to the inner (closest to
powerhead) oil manifold port.
1
Install cylinder #2 oil hose to the outer (furthest
from powerhead) oil manifold port.
Loop the cylinder block oil distribution hose over
the crankcase oil distribution hose and install to
the rear oil manifold port.
Install cylinder #1 oil distribution hose to the
inboard (closest to powerhead) oil manifold port.
007330
1
007333
DO NOT insert distribution hoses