The oil manifold distributes the oil supplied by the
pump.
3
1. Oil injector pump
2. Oil distribution manifold
3. Pickup tube and filter
Electrical Circuit (55 V)
The oil injector is powered by the 55 V electrical
circuit. The EMM controls pump operation by rap-
idly connecting and disconnecting the pump's
internal coil to ground.
The EMM monitors the oil injection pump electri-
cal circuit. If circuit voltage is beyond the specified
range, or the circuit is open, the EMM:
Activates S.A.F.E.
Stores a service code 34
EMM LED 4: ON (Running)
Engine Monitor LOW OIL display: ON
LOW OIL Warning
A switch in the oil tank assembly monitors the oil
level in the oil tank.
If the oil level falls below one-quarter capacity, the
2
EMM begins counting oil pump pulse cycles.
When it reaches 1000 pulses, the EMM signals:
Engine Monitor LOW OIL display: ON
1
Approximate oil reserve at Low Oil activation:
•
0.375 qt. (0.35 l).
NO OIL Warning
After LOW OIL is displayed, the EMM counts oil
pump pulse cycles again. When it reaches 6700
pulses, the EMM:
Activates S.A.F.E.
Stores service code 117
EMM LED 4: ON (Running)
Engine Monitor LOW OIL display: ON
007321
To recover from S.A.F.E. mode:
•
Oil level must be above one-quarter
•
The warning resets after three oil pump pulse
cycles when the outboard has been stopped
and restarted.
If outboard has been run for more than 3 hours
with NO OIL faults (codes 34 & 117), the EMM
Activates SHUTDOWN
Stores service code 33
EMM LED 4: FLASHING
Engine Monitor LOW OIL display: FLASHING
OILING SYSTEM
COMPONENTS
8
147