BRP Evinrude E-TEC Series Service Manual page 142

FUEL SYSTEM
FUEL COMPONENT SERVICING
Prime screw threads with Locquic Primer and let
dry. Apply Ultra Lock to threads. Position reed
valve on reed plate and install screws. Tighten
screws to a torque of 35 to 60 in. lbs. (4.0 to 6.8
N·m).
Installation
Place reed plate assembly on cylinder/crankcase.
Apply Nut Lock to reed plate screws. Install and
tighten screws to a torque of 84 to 106 in. lbs. (9.5
to 12 N·m).
Place gasket on throttle body. Install throttle body
on reed plate and install new screws.
IMPORTANT:
If old screws must be re-used,
make sure all previous thread locking material is
removed and apply Nut Lock to threads.
140
Tighten the center screws first and expand out-
ward. Tighten in stages to a final torque of 84 to
106 in. lbs. (9.5 to 12 N·m).
Install vapor separator vent hose and main bear-
007432
ing vent hose. Secure with tie straps.
Install crankshaft position sensor, and throttle
position sensor electrical connectors.
Connect throttle linkage.
IMPORTANT:
ages.
1
007433
1. Throttle linkage
Refer to TPS Calibration on p. 106.
DO NOT lubricate throttle link-
007434
007435