BRP Evinrude E-TEC Series Service Manual page 139

Install vapor separator assembly onto the four fuel
injector fittings.
1. Fuel injector fittings
Install three vapor separator retaining screws.
Tighten two vapor separator to fuel injector mount-
ing screws to a torque of 29 to 48 in. lbs. (3.3 to
5.5 N·m).
2
1. Vapor separator to fuel injector mounting screws
2. Vapor separator to powerhead mounting screw –
Leave LOOSE at this time
IMPORTANT:
Fuel injector screws must be
tightened before vapor separator to powerhead
mounting screw.
Tighten injector screws in stages, starting with the
lower screw.
•
First torque is 4.5 ft. lbs. (6 N·m).
•
Second torque is 9 ft. lbs. (12.2 N·m).
•
Third torque is 14 ft. lbs. (19 N·m).
FUEL COMPONENT SERVICING
•
Final torque is 22 to 23.5 ft. lbs. (30 to 32 N·m).
1
1
Tighten Screws in Stages
007101
Tighten vapor separator to powerhead mounting
screw to 29 to 48 in. lbs (3.3 to 5.5 N·m).
1. Vapor separator to powerhead mounting screw
1
Install fuel supply hose. Secure with Oetiker
clamps. Reinstall vapor separator vent hose and
cooling water hoses. Secure with tie straps.
Attach fuel filter to vapor separator with tie strap.
007102
Reinstall protective cap on the pressure test fit-
ting. Reconnect fuel injector electrical connectors.
FUEL SYSTEM
I
I
007103
1
7
007104
007287
137