Fuel Lift Pump Service; Vapor Separator And Fuel Injector Service - BRP Evinrude E-TEC Series Service Manual

FUEL SYSTEM
FUEL COMPONENT SERVICING

Fuel Lift Pump Service

The fuel lift pump is serviceable as a complete
assembly. Refer to parts catalog for service parts.
Removal
Disconnect the battery cables at the battery.
Remove port lower motor cover. Refer to Lower
Cover Removal.
Remove the oil tank. Refer to Oil Tank Assembly
on p. 155.
Use an appropriate tool to remove the push nuts
that retain fuel pump to oil tank.
Remove the fuel hoses from the fuel pump hous-
ing.
1
1. Fuel pump housing
Remove the fuel lift pump.
132
Installation
Connect the fuel hoses to the fuel pump. Secure
with Oetiker clamps.
Place fuel pump in position on the oil tank. Secure
the fuel pump with new pushnuts, P/N 354365.
1. Push nuts
Be sure fuel hoses are routed in channels on oil
tank. Install the oil tank. Refer to Oil Tank Assem-
bly on p. 155.
Squeeze primer bulb to prime fuel system. Hold
pressure on bulb and check for fuel leaks.
Connect battery cables.
Run outboard and check for fuel leaks.
007410
Vapor Separator and Fuel Injector
Service
Vapor Separator Removal
Relieve fuel system pressure. Refer to Relieving
Fuel System Pressure on p. 130.
Disconnect the battery cables at the battery.
Remove oil tank. Refer to Oil Tank Assembly on
p. 155.
1
007422