Fuel Filter Service - BRP Evinrude E-TEC Series Service Manual

Wrap a shop towel completely around the pres-
sure test valve while connecting fitting from Fuel
Pressure Gauge, P/N 5007100, to test fitting of
fuel pump/vapor separator assembly.
1. Test fitting
Insert venting hose of gauge into a suitable con-
tainer.
Slowly open gauge's venting valve.
Clean up any spilled fuel with shop towels.
1
1. Test fitting
2. Venting valve
3. Venting hose
FUEL COMPONENT SERVICING

Fuel Filter Service

Removal
Disconnect the battery cables at the battery.
Remove filter carefully to prevent spilling contents.
1
Inspect contents for any presence of water. If
water is present, identify the source and correct
the problem. Take additional fuel samples and
drain fuel tank(s) if necessary.
1
007096
1. Fuel filter flange
2
Installation
Install filter in fuel supply hoses. Flanged part of
filter is up. Secure filter with appropriate clamps.
3
Squeeze primer bulb to prime fuel system. Hold
pressure on bulb and check for fuel leaks.
Connect battery cables.
Run outboard and check for fuel leaks.
007097
FUEL SYSTEM
007273
7
131