Service Specifications - BRP Evinrude E-TEC Series Service Manual

REFERENCE INFORMATION

SERVICE SPECIFICATIONS

SERVICE SPECIFICATIONS
Full Throttle
Operating Range RPM
Power
Idle RPM in Gear
Idle RPM in Neutral
Weight
(may vary depending
on model)
Lubrication
Engine Type
Displacement
Bore
Stroke
Standard Bore
Top Crankshaft Journal
Center Crankshaft Journal
Bottom Crankshaft Journal
Rod Crankpin
Piston Ring End Gap, Both
Fuel/Oil Control
Starting Enrichment
Minimum (High) Fuel Pressure
Minimum Fuel Lift
Pump Pressure
Maximum Fuel Inlet Vacuum
Minimum Octane
Additives
10
15 HO Models
15 HP – 5500 to 6100 RPM
15 HP (11.2 kw) @ 5800 RPM
750 ± 50 EMM Controlled
700 ± 50 EMM Controlled
(DHPL) Models: 181 lbs. (82 Kg)
(DHTL) Models: 187 lbs. (85 Kg)
Evinrude/Johnson XD100, XD50, XD30; or
In-line, 2 Cylinder, Two-Cycle
2.9916 to 2.9931 in. (75.989 to 76.026 mm)
To bore oversize, add piston oversize dimension to standard bore
1.6235 to 1.6245 in. (41.237 to 41.262 mm)
1.7461 to 1.7470 in. (44.350 to 44.375 mm)
2.0450 to 2.0459 in. (51.942 to 51.967 mm)
1.1815 to 1.1817 in. (30.011 to 30.016 mm)
0.011 to 0.019 in. (0.30 to 0.50 mm)
28 to 32 psi (193 to 220 kPa)
87 AKI (R+M)/2 or 90 RON
®
2+4 Fuel Conditioner, Fuel System Cleaner
Use of other additives may result in engine damage.
See FUEL SYSTEM REQUIREMENTS on p. 120 for additional information
25 – 30 HP Models
25 HP – 5500 to 6100 RPM
30 HP – 5500 to 6100 RPM
25 HP (30 kw) @ 5800 RPM
30 HP (37 kw) @ 5800 RPM
(R) Models: 152 lbs. (69 kg)
(RL) Models: 156 lbs. (71 kg)
(TE) Models: 166 lbs. (105 kg)
(TEL) Models: 170 lbs. (75 kg)
(DTL) Models: 191 lbs. (86 kg)
(DEL) Models: 164 lbs. (74 kg)
(PL) Models: 185 lbs. (84 kg)
NMMA TC-W3 certified
35.1 cu. in. (575 cc)
2.992 in (76 mm)
2.500 in. (63.50 mm)
EMM Controlled
EMM Controlled
2 psi (14 kPa)
4 in. Hg.