BRP Evinrude E-TEC Series Service Manual page 115

1
1. Locking tab, plug
2. Locking tab, receptacle
Terminal Installation
Align terminal with connector housing. Push con-
nector and seal into housing until seated.
1
1. Terminal and seal
Align anti-backout device with connector housing
and terminals. Use Secondary Lock Installer,
P/N 777079, to seat device in connector.
Crimping Terminals
Crimping Superseal 1.5 terminals requires AMP
Crimp Tool with dies, P/N 777281.
2
1. Terminal
2. Seal
S S
UPER EAL
The J1-A connector of the EMM is an AMP Super
Seal connectors.
Disconnect
2
Depress BOTH latches and pull connector from
plug.
Connect
Push connector into plug until latches engage.
002447
1
1. Latch
Terminal Removal
Open lock mechanism and remove terminal from
connector housing.
002451
2
1
1. Latch
2. Lock mechanism
1
Terminal Installation
Push terminal through seal until it is seated in con-
nector housing. Close lock mechanism.
1
002452
1. Terminal
ELECTRICAL AND IGNITION
CONNECTOR SERVICING
6
007353
2
1
002453
002454
113