Electric Starter Servicing; Starter Removal; Starter Disassembly - BRP Evinrude E-TEC Series Service Manual

ELECTRIC STARTER
SERVICING

Starter Removal

IMPORTANT:
Do not clean the starter drive
while the starter motor and drive are installed on
the powerhead. The cleaning agent could drain
into the starter motor, washing dirt from the drive
into the starter bearings and commutator.
Disconnect the battery cables at the battery.
Remove lower motor covers. Refer to Lower
Cover Removal on p. 45.
Remove the starter positive (+) cable from post on
starter.
Remove three starter mounting screws. Remove
the starter.
1
1. Screws

ELECTRIC STARTER SERVICING

Starter Disassembly

Remove the retaining nut, spacers, spring and
starter pinion from pinion shaft.
Mark the end cap and brush holder cap orienta-
tion. Remove the two thru-bolts.
1
007253
Remove the end cap and thrust washer.
ELECTRICAL AND IGNITION
007438
007439
6
002296
002298
107