Ignition Coil Servicing; Ignition Coil Removal; Ignition Coil Installation - BRP Evinrude E-TEC Series Service Manual

Thoroughly clean the crankshaft and flywheel
tapers with Cleaning Solvent
Align the flywheel keyway and install flywheel.
Coat the threads of the flywheel nut with Triple-
Guard grease.
Install the washer and nut and tighten to a torque
of 66 to 70 ft. lbs. (90 to 95 N·m).
NOTICE
To prevent damage to crankcase or
cylinder block, DO NOT allow Flywheel Holder
to rest against recoil starter mounting boss.
Replace recoil starter.
IMPORTANT:
Check ignition timing after fly-
wheel removal or replacement. Refer to TIMING
ADJUSTMENTS on p. 106.
and let dry.
™
002093
007361
ELECTRICAL AND IGNITION

IGNITION COIL SERVICING

IGNITION COIL
SERVICING

Ignition Coil Removal

Remove spark plug lead from ignition coil and dis-
connect ignition coil electrical connector.
Remove two ignition coil retaining screws.
Do not lose the rubber washers between coil and
bracket.
1
1. Screws

Ignition Coil Installation

Install one rubber washer on each screw and
install screw through ignition coil.
Install remaining rubber washers on screws
between coil and bracket.
1
1. Rubber washers
Install coil on bracket. Tighten screws to a torque
of 31 to 49 in. lb. (3.5 to 5.5 N·m).
Install spark plug lead on ignition coil and connect
ignition coil electrical connector.
1
6
008193
008188
105