BRP Evinrude E-TEC Series Service Manual page 104

ELECTRICAL AND IGNITION
SystemCheck CIRCUIT TESTS
the two connectors, replace SystemCheck
gauge.
2
1. Purple wire
2. Tan/blue wire
Turn the key switch OFF and reconnect all discon-
nected circuits.
102
1
DRC6280
LOW OIL Circuit Test
Turn the key switch ON. Using a jumper wire, con-
nect tan/black wire (pin 4) of the engine harness
connector to a clean engine ground. The LOW
OIL light should turn on after 40 seconds.
If the LOW OIL light does not turn on after con-
necting the terminal to ground, test circuit for con-
tinuity.
Turn the key switch OFF and reconnect all discon-
nected circuits.
002079