Ricoh RF IDeas Ethernet 241 Settings Manual

External Ethernet Card Reader Setting Guide
Trademarks
Ethernet 241 is a trademark of RF IDeas Inc.
Other product names used herein are for identification purposes only and might be
trademarks of their respective companies. We disclaim any and all rights to those marks.
Introduction
The following two types of Ethernet card readers are supported by RICOH Streamline NX
version 3.1: RF IDeas Ethernet 241 and Inepro IP Reader.
When a user logs in to the device by holding the card over the card reader, all print jobs owned
by the logged-in user will be printed. The logged-in user cannot perform other operations,
such as selecting jobs to be printed or using delivery services, and so on.
To use the Ethernet card reader, the following configurations are necessary:
Installing the optional support when installing the Delegation Server

Associating the Ethernet card reader with a Delegation Server (Ethernet 241 only)

Mapping the Ethernet card reader with a Device (Inepro IP Reader only)

To set up Inepro IP Reader to send card information to the Delegation Server, the

configuration tool for the reader is necessary. Ask the dealer for the tool at the time of
purchase.
Installing Support for Ethernet Card Reader
Install the optional support for the Ethernet connected card readers as follows:
1. During the installation of RICOH Streamline NX Delegation Server, select [Custom] on
the "Setup Type" window.
2. Select [External Card Reader: RF Ideas Ethernet 241] and/or [External Card Reader:
Inepro IP Reader] under [Options].
3. Complete the installation process.
1