ELECTRICAL
STARTER MOTOR
Apply Moly Lube to the armature shaft and the
shaft bore in the front cover.
IMPORTANT:
When installing the armature, be
careful not to break any brushes in the brush
holder.
Install the stator, the bottom washer, the armature,
two (2) washers, and the shim on the rear cover.
Install the front cover and two (2) through bolts.
Tighten the bolts securely.
1
2
3
4
1. Front cover
2. Washers and shim
3. Armature
4. Bottom washer
5. Stator
6. Rear cover
7. Through bolt (2)
96
IMPORTANT:
with the tab on the stator when assembling the
starter motor.
1
1. Notches
5
When removing or installing any type of
retaining rings, wear eye protection to
avoid personal injury.
Install the pinion, the spring, the pinion stop, and
6
the stop ring. Make sure that the stop ring fits
tightly in the pinion stop and around the armature
shaft.
7
1
2
3
001719
4
1. Stop ring
2. Pinion stop
3. Spring
4. Pinion
Align the notches in the covers
WARNING
001720
1
2
3
4
001721