Use Universal Puller Set, P/N 378103, to loosen
the flywheel from the crankshaft.
1
1. Flywheel remover
Remove the flywheel bolt, the washer, and the key
from the crankshaft. Remove the flywheel.
1. Bolt
2. Washer
3. Key
4. Flywheel
Installation
Clean the mating surfaces of the flywheel and the
crankshaft with cleaning solvent.
Install the flywheel on the crankshaft. Install the
key in the notch on the crankshaft.
Install Flywheel Holder, P/N 5034227, on the fly-
wheel.
REMOVAL AND INSTALLATION
Apply engine oil to the threads of the flywheel bolt.
Install the washer and the bolt. Tighten the bolt to
a torque of 140 ft. lbs. (190 N·m).
1
001678
1. Flywheel holder
2. Flywheel
Charge Coil and Crankshaft
1
Position Sensors
2
Removal
Remove the flywheel.
3
Remove the screws and both sensors. Then dis-
connect the sensor connectors.
4
001679
1. Crankshaft position sensors (2)
ENGINE CONTROL
2
001681
1
001654
81
4