ENGINE CONTROL
REMOVAL AND INSTALLATION
Checking the Cylinder Temperature
Sensor Resistance
Remove the cylinder temperature sensor.
1. Cylinder temperature sensor
Connect an ohmmeter between the sensor lead
wires.
Immerse the sensor's tip in a container of water
and gradually heat the water while monitoring the
changes in sensor resistance.
If the measurements are out of specification,
replace the cylinder temperature sensor.
Test probe connection
Red (+)
Violet
Cylinder Temperature Sensor Resistance
Water temperature
32°F (0°C)
77°F (25°C)
122°F (50°C)
135° (75°C)
1
2
1. Thermometer
2. Heater
80
1
001672
Black (–)
Black
Resistance
5.30 - 6.60 ohms
1.80 - 2.30 ohms
0.73 - 0.96 ohms
0.33 - 0.45 ohms
001673
REMOVAL AND
INSTALLATION
Flywheel
Removal
Disconnect the battery cables at the battery.
Remove three (3) bolts and the flywheel cover.
1
1. Bolts (3)
2. Flywheel cover
Install Flywheel Holder, P/N 5034227, and loosen
the flywheel bolt three (3) turns.
IMPORTANT:
Do not remove the flywheel bolt
at this time. This bolt prevents damage to the
crankshaft when using the flywheel removal tools.
1
1. Flywheel holder
2. Flywheel
2
001394
2
001677